M P B - 3 0 3 2 A T FUJITSU
Native| Translation
------+-----+-----+-----
Form 3.5"/SLIMLINE Cylinders 8982| 6704| |
Capacity form/unform 3240/ MB Heads 3| 15| |
Seek time / track 11.0/ 2.5 ms Sector/track | 63| |
Controller ULTRA ATA Precompensation
Cache/Buffer 256 KB Landing Zone
Data transfer rate 10.000 MB/S int Bytes/Sector 512
33.300 MB/S ext UDMA
Recording method PRML 8/9 operating | non-operating
-------------+--------------
Supply voltage 5/12 V Temperature *C 5 55 | -40 60
Power: sleep W Humidity % 8 80 | 5 85
standby W Altitude km -0.060 3.000| -0.060 12.000
idle 4.0 W Shock g 10 | 75
seek W Rotation RPM 5400
read/write 4.4 W Acoustic dBA
spin-up W ECC Bit SMART
MTBF h 500000
Warranty Month
Lift/Lock/Park YES Certificates
**********************************************************************
L A Y O U T
**********************************************************************
FUJITSU MPB-3021AT/3032AT/3043AT/3052AT/3064AT JUMPER SETTING
+---------------------------------------------------------+
| |XX
| |XXI
| |XXN
| |XXT
| |XXE
| |XXR
| |XXF
| |XXA
| |XXC
| |XXE
| |XX
| |+-+Master
| || |/Slave
| |+-+
| |XX Power
| |XX
+---------------------------------------------------------+
**********************************************************************
J U M P E R S
**********************************************************************
FUJITSU MPB-3021AT/3032AT/3043AT/3052AT/3064AT JUMPER SETTING
Jumper Setting
==============
Master Drive
------------
+--2-4-6+
| X * *|
| X xxx|
+--1-3-5+
Slave Drive
-----------
+--2-4-6+
|xxx * *|
| * xxx|
+--1-3-5+
Cable Select Mode Setting (CSEL)
--------------------------------
Cable select mode gives an alternative method by which the drive may
be set to Master or Slave. A special cable is needed to implement
this features and should only be used if supported by BOTH drives.
+--2-4-6+
| xxx *|
| * xxx|
+--1-3-5+
********************************************************************
Spare Jumper Settings
---------------------
If the drive cannot be recognized by the system, due to non-
translating BIOS (legacy), which does not allow drives with
capacities greater than 2.1GB, the following jumper setting should be
applied.
Master Drive Setting
--------------------
+--2-4-6+
| X * X|
| X * X|
+--1-3-5+
Slave Drive Setting
-------------------
+--2-4-6+
|xxx * X|
| * * X|
+--1-3-5+
Cable Select Mode Setting (CSEL)
--------------------------------
+--2-4-6+
| xxx X|
| * * X|
+--1-3-5+