C F S - 5 4 1 A C A B O CONNER
NO MORE PRODUCED Native| Translation
------+-----+-----+-----
Form 3.5"/SLIMLINE Cylinders | 1048| 524| 1024
Capacity form/unform 540/ MB Heads 2| 16| 32| 16
Seek time / track 14.0/ 3.0 ms Sector/track | 63| 63| 63
Controller IDE / ATA2 FAST/ENHA Precompensation
Cache/Buffer 64 KB Landing Zone
Data transfer rate MB/S int Bytes/Sector 512
16.600 MB/S ext
Recording method RLL 1/7 operating | non-operating
-------------+--------------
Supply voltage 5/12 V Temperature *C 5 55 | -40 60
Power: sleep 1.0 W Humidity % 8 80 | 8 80
standby W Altitude km -0.061 3.048| -0.061 12.192
idle 3.8 W Shock g 5 | 75
seek 5.7 W Rotation RPM 3600
read/write 4.9 W Acoustic dBA 34
spin-up W ECC Bit
MTBF h 300000
Warranty Month 36
Lift/Lock/Park YES Certificates
**********************************************************************
J U M P E R S
**********************************************************************
SEAGATE ST3541A STINGRAY QUICK REFERENCE GUIDE
Jumper Setting
==============
C/D Master/Slave Configuration
------------------------------
CLOSED Single Drive
CLOSED Master Drive
OPEN Slave Drive
CS Cable Select
---------------
OPEN Cable select option disabled
CLOSED Cable select option enabled
NOTE
When using the CS option, the C/D jumper must be open.
Front View +---- NOT USED
| +-- Master ON, Slave OFF (C/D)
| |
(TOP) o o o o o o o o1
Option Block --- o o o o---o o o2------------------
(BOTTOM) +---+---+ |
| |
RESERVED ---+ |
Cable Select ------+
The C/D jumper is used to determine whether the drive is a master
(drive C) or a slave (drive D). The drive is configured as a master,
when jumpered, and a slave when not jumpered.
When using CS option, the C/D jumper MUST be open
Master/Slave Configuration
--------------------------
When two drives are daisy-chained on the host interface, one must be
designated at the master drive (C: drive) and one as the slave drive
(D: drive). Commands from the host are written in parallel to both
drives.
When the C/D jumper on the drive is closed, the drive will assume the
role of a master. When C/D is open, the drive will act as a slave. In
single-drive configurations, C/D must remain in the closed (master)
position.
Cable Select
------------
This optional method of drive master/slave designation can be enabled
by jumper selection as described below. If used, special cabling can
be used to selectively ground the CSEL interface signal of the
drive intended to be drive C (0). This drive will then function as
the master. If CSEL is allowed to float the drive will recognize it-
self as drive D (1) and function as the slave.