C P - 2 2 5 4 CONNER
NO MORE PRODUCED Native| Translation
------+-----+-----+-----
Form 3.5"/HH Cylinders 1339| 489| |
Capacity form/unform 250/ MB Heads 6| 16| |
Seek time / track / ms Sector/track | 63| |
Controller IDE / AT Precompensation
Cache/Buffer KB Landing Zone
Data transfer rate MB/S int Bytes/Sector 512
MB/S ext
Recording method RLL operating | non-operating
-------------+--------------
Supply voltage Temperature *C |
Power: sleep W Humidity % |
standby W Altitude km |
idle W Shock g |
seek W Rotation RPM
read/write W Acoustic dBA
spin-up W ECC Bit
MTBF h
Warranty Month
Lift/Lock/Park YES Certificates
**********************************************************************
J U M P E R S
**********************************************************************
CONNER QUICK INSTALLATION GUIDE L-511-1008 11/93 AT-BUS
QUICK INSTALLATION GUIDE
------------------------
AT-BUS
------
Table 1
+---------------------------------------+
|Single Drive = Jumper ACT and C/D |
|Master Drive = Jumper ACT, C/D and DSP |
|Slave Drive = No jumpers installed |
+---------------------------------------+
Table 2
+------------------------------------+
|Single Drive = Jumper C/D |
|Master Drive = Jumper C/D and E-1 |
|Slave Drive = No jumpers installed |
+------------------------------------+
Table 3
+-----------------------------------+
|Single Drive = Jumper E-1 |
|Master Drive = Jumper E-1 |
|Slave Drive = No jumpers installed|
+-----------------------------------+
Table 4
+-----------------------------------+
|Single Drive = Jumper M/S |
|Master Drive = Jumper M/S |
|Slave Drive = No jumpers installed|
+-----------------------------------+
Table 5
+-----------------------------------+
|Single Drive = Jumper C/D |
|Master Drive = Jumper C/D |
|Slave Drive = No jumpers installed|
+-----------------------------------+
Table 6
+-----------------------------------+
|Single Drive = Jumper C/D |
|Master Drive = Jumper C/D and DSP |
|Slave Drive = No jumpers installed|
+-----------------------------------+
Table 7
+----------------------------------+
|Single Drive = Jumper C/D and DSP |
|Master Drive = Jumper C/D and DSP |
|Slave Drive = Jumper DSP |
+----------------------------------+
Table 8
+---------------------------------+
|Single Drive = Jumper Pins 1-2 |
|Master Drive = Jumper Pins 1-2 |
|Slave Drive = No Jumper Pins 1-2|
+---------------------------------+
LED Configuration Table
-----------------------
Letter Connector LED+ LED-
A J-4 Pin 1 Pin 2
B J-1 Pin 3 Pin 4
C J-5 Pin 3 Pin 4
D J-3 Pin 3 Pin 4
E J-7 Pin 1 Pin 2
F J-5 Pin 7 Pin 8
All Conner drives are shipped with jumpers to configure the drive in
the Single (Master) mode.
Conner drives are low-level formatted at the factory.